Finivlam S for (half) synthetic fibres |
<< Previous - Next >> |
Finivlam S can 5 literReady to use. To be used for natural, mixed and synthetic fibres for about 50 m² Article code: Finivlam S5
|
||
|
Finivlam® S
Finivlam® S can be applied on synthetic and mixture fibres of:
Textile fibres
The fibres must be absorbent. You can easily check that yourself, by dripping water
on the surface. When the water attracts in the fibres. Then is our product suitable
for impregnation of your object. When the water runs right off again then the same
will happen with our product and creates no or inadequate protection, there is also a
possibility that residue formation occurs in the form of a slight haze and / or dried
droplets. When you about to apply Finivlam the surface should be dry.
We advise you Finivlam® S when your about to impregnate an object consisting
Synthetic fibres. If you’re not familiar whit the composition of your fibres, we
recommend you also Finivlam ® S.
Synthetic fibres
(*) are half synthetic fibres
Caution!
Finivlam® S is for indoors use only. The guaranty will expire when you clean, wash or
treat the impregnated surface with other products. After you cleaned the surface,
you should impregnate the surface again.
euro 75.00
Discount scheme: |
